How to position a spoilboard
Positioning and aligning of spoilboard is important as it will allow you to:
-
Align your stock material using spoilboard’s edge as a reference.
-
Prevent the moving parts of SmartBench interfering with the spoilboard during a job.
Unclamp the Upper X Beam, raise it high enough to accommodate the total thickness of the spoilboard and the stock material you are planning to use; then reclamp the Upper X Beam in the raised position to prevent it sliding down and locking the materials.
Position the spoilboard roughly in the centre of the Y Bench.
A: Spoilboard
B: Straight edge
M1 and M2: Measurement points
Using a tape measure align the spoilboard with the side of the Y Bench.
We assume the spoilboard has a straight edge, which we can use to align it along the Y axis. |
Measure the distance between the edge of the spoilboard and the side of the Y Bench at two points (e.g. M1 and M2), as far apart as possible.
Repeat the operation several times until the edge of the spoilboard is aligned with the Y Bench.