Unboxing

What is in the box?

SmartBench is packed in four different boxes. The table below represents what each box contains.

Box 1	1 x Z head assembly (including spindle) 1x SmartBench console 1x Dust shoe plug
Box 2	1x Upper X beam 1x Lower X beam
Box 3	2x Pairs of legs 2x Power cables (One for the Smartbench input, one for the extractor input) 1x Extraction extension cable (To be plugged into extraction output) 1x USB Stick 1x 6mm T handle driver 1x Wheel setting tool 1x Console safety bond 1x Collet (1/ 4”) 1x Collet Spanner 1x Spindle Motor
Box 4	1x Y Bench

Unboxing the boxes

Follow the guide below to unbox the SmartBench, which will later help with the installation process.

Please check the contents. If any of the above items are damaged or missing, please contact your point of purchase immediately.

Box 1 unboxing

Box 1 contains the Z head.

After cutting the tape, on top of the packaging there are some safety instructions and user guides as shown below.

The following documents are enclosed:

A: Yeti tool thank you note

B: Packing checklist

C: Information on the brushes

D: Quick start guide

E: Safety instructions

Remove the top layer of foam.

The Z head box also contains:

F: Z head

G: Yeti hat

H: Dust shoe plug

I: Console

When the box is unpacked, your Z head (F), console (I) and dust shoe plug (H) should look like this:

Box 2 unboxing

Box 2 contains both upper and lower X beams.

Cut the tapes.

Open the packaging.

The upper and lower X beams should look like this:

J: Upper X beam

K: Lower X beam

The upper X-Beam will come clamped to the lower X-Beam, it is simplest to take them out of the box together and then release them by lifting the clamp handles on either end.

Box 3 unboxing

Box 3 contains a pair of legs (2x) and a toolbox.

Cut the tapes and open the box.

The tool kit is located below the leg pairs as shown below.

L: Leg pair

M: Toolbox

The expected unboxing should look like this:

L: Leg pair (2x)

M: Toolbox

Toolbox unboxing

The toolbox contains all the necessary tools for the SmartBench.

The toolbox includes the following:

N: 6mm T handle driver

O: Console safety bond

P: USB flash drive

Q: Collet (8mm)

R: Wheel setting tool

S: Collet (1/ 4”)

T: Spindle Motor *Don't forget to remove the clamping warning sticker before use*

U: Collet Spanner

Box 4 unboxing

Box 4 contains the Y bench assembly. Look for the label that says “OPEN THIS SIDE”.

V: Strap

Lay the box flat on it's other side, making sure the “Open this side” label is facing up. Remove the top latches and the screws on each end and the sides with a screwdriver or drill.

W: Latch

After removing the top latch plates and screws, the cover can be easily lifted off as shown below. The Y bench can then be lifted out of the box.

X: Y bench

Y: Support wooden block

First setup