Unboxing
What is in the box?
SmartBench is packed in four different boxes. The table below represents what each box contains.
Box 1 |
1 x Z head assembly (including spindle) 1x SmartBench console 1x Dust shoe plug |
Box 2 |
1x Upper X beam 1x Lower X beam |
Box 3 |
2x Pairs of legs 1x Power cable 1x Extraction cable 1x USB Stick 1x 6mm T handle driver 1x Wheel setting tool 1x Console safety bond 1x Collet (1/ 4”) 1x Collet Spanner |
Box 4 |
1x Y Bench |
Unboxing the boxes
Follow the guide below to unbox the SmartBench, which will later help with the installation process.
|
Please check the contents. If any of the above items are damaged or missing, please contact your point of purchase immediately. |
Box 1 unboxing
Box 1 contains the Z head.
After cutting the tape, on top of the packaging there are some safety instructions and user guides as shown below.
The following documents are enclosed:
A: Yeti tool thank you note
B: Packing checklist
C: Information on the brushes
D: Quick start guide
E: Safety instructions
Remove the top layer of foam.
The Z head box also contains:
F: Z head
G: Yeti hat
H: Dust shoe plug
I: Console
When the box is unpacked, your Z head (F), console (I) and dust shoe plug (H) should look like this:
Box 2 unboxing
Box 2 contains both upper and lower X beams.
Cut the tapes.
Open the packaging.
The upper and lower X beams should look like this:
J: Upper X beam
K: Lower X beam
Box 3 unboxing
Box 3 contains a pair of legs (2x) and a toolbox.
Cut the tapes and open the box.
The tool kit is located below the leg pairs as shown below.
L: Leg pair
M: Toolbox
The expected unboxing should look like this:
L: Leg pair (2x)
M: Toolbox
Toolbox unboxing
The toolbox contains all the necessary tools for the SmartBench.
The toolbox includes the following:
N: USB stick
O: Extraction cable
P: Power cable
Q: Console safety bond
R: Collet spanner
S: Wheel setting tool
T: Collet (1/ 4”)
U: 6mm T handle driver
Box 4 unboxing
Box 4 contains the Y bench assembly. Look for the label that says “OPEN THIS SIDE”.
V: Strap
Lay the box flat on it's other side, making sure the “Open this side” label is facing up. Remove the top latches and the screws on each end and the sides with a screwdriver or drill.
W: Latch
After removing the top latch plates and screws, the cover can be easily lifted off as shown below.
To take the Y bench out, unscrew the four support wooden blocks with a screwdriver or drill.
X: Y bench
Y: Support wooden block